Chauvet Obey 70 User Manual download pdf (Page 9)

3. Setup 9 10/28/2010 4:27 PM

3. SETUP

AC Power

This fixture requires an external power supply, which is included. The included power supply is rated

for 100~240 VAC, 50/60 Hz, 500 mA max. Before powering on the unit, make sure the line voltage

to which you are connecting it is within the range of accepted voltages.

To determine the power requirements for a particular fixture, see the label affixed to the back plate

of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its

average current draw under normal conditions.

Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat

(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a

0 to 100% switch.

Mounting

Orientation

The Obey™ 70

may be mounted in any safe position.

Installation

Please see the drawing below, which shows the back of the controller. It details the dimensions for

mounting. This will aid in placing the holes for installation.

Fixture Addressing

The Obey™ 70 can control up to 12 separate fixtures. Each fixture must be set to predetermined

DMX addresses. Please see the chart below for the DMX starting addresses of each of the twelve

fixtures.

IXTURE

DDRESS

DIP

SWITCH

IXTURE

DDRESS

DIP

SWITCH

IXTURE

DDRESS

DIP

SWITCH

1 1 1 5 129 1,8 9 257 1,9

2 33 1,6 6 161 1,6,8 10 289 1,6,9

3 65 1,7 7 193 1,7,8 11 321 1,7,9

4 97 1,6,7 8 225 1,6,7,8 12 353 1,6,7,9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Chauvet Obey 70 User Manual Page 9