Chauvet B-250 Operations Instructions download pdf (Page 17)

DMX-1655 Manual Version 1.11 17

1717

Inserting/Exchanging rotating gobos

Open the cover by loosening the fastening

screw at the sides of the cover. Remove

the “O” ring w ith tw eezers if available,

insert the new gobo and replace the “O”

ring.

Lamp replacement

Because of its high internal pressure, there might be a risk that the Discharge lamp

could explode during operation. The lamp emits intense UV radiation which is

harmful to the eyes and skin. The high luminance of the arc can cause severe

damage to the retina if you look directly into the lamp source.

Alw ays switch off the main supply and never handle the lamp or luminaries w hen

it is hot.

Do not touch the bulb with bare hands. If this happens, clean the lamp with

alcohol and w ipe it with a lint free cloth before installation.

The lamp generates UV radiation. Never operate the lamp without appropriate

shielding.

When burning, the lamp operates at high pressure and there is a slight risk of arc

tube rupture. The risk increases w ith age, temperature and improper handling of

the lamp. Do not use the lamp any longer than its specified life.

Make sure the lamp is located in the

center of the reflector for the best spot.

Adjust lamp position by screws A, B

and C.

When replacing lamp, please wait 15 minutes after

powering down to allow the unit cool down!

CAUTION!

Sw itch off device before

exchanging gobos or colors.

CAUTION!

Never unscrew the screws of the

rotating gobo as the ball bearing will

otherw ise be opened!

1 2 ... 12 13 14 15 16 17 18 19

No comments

Chauvet B-250 Operations Instructions Page 17