Chauvet B-250 Operations Instructions download pdf (Page 7)

DMX-1655 Manual Version 1.11 7

Before you Begin

Unpacking Instructions

Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have

been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear

damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials. In the event that a

fixture must be returned to the factory, it is important that the fixture be returned in the original factory box and packing.

Mounting

The unit should be mounted via its mounting system

( as show n to the right ) on the bottom of the base.

Use clamps to fix the unit to truss. Alw ays ensure that

the unit is firmly fixed to avoid vibration and slipping

while operating. Always ensure that the structure to

which you are attaching the unit is secure and is able

to support a w eight of 30 kgs for each unit.

This fixture may be mounted in any position

provided there is adequate room for ventilation. It is

important never to obstruct the fan or vents pathway.

Mount the fixture using, preferably the center

mounting holes and a suitable “C” or “O” type

clamp. Adjust the angle of the fixture by loosening

both knobs and tilting the fixture. After finding the

desired position, retighten both knobs. When

selecting installation location, take into consideration

lamp replacement access and routine maintenance.

Safety cables should always be used. Never mount in

places where the fixture w ill be exposed to rain, high

humidity, extreme temperature changes or restricted

ventilation.

Powering

To determine the pow er requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the

fixture’s specifications chart. A fixture’s listed current rating is its average current draw under normal conditions. All fixtures must be

pow ered directly off a sw itched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or

dimmer channel is used solely for a 0% to 100% sw itch. Before applying power to a fixture, check that the source voltage matches the

fixture’s requirement. All fixtures must be connected to circuits with a suitable Earth Ground. Check the fixture or device carefully to

make sure that if a voltage selection sw itch exists that it is set to the correct line voltage you will use.

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

No comments

Chauvet B-250 Operations Instructions Page 7