Chauvet B-250 Operations Instructions Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 19
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
DMX-1655 Manual Version 1.11 4
44
4
Introduction
Safety Instructions
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this
instruction booklet.
Alw ays make sure that you are connecting to the proper voltage and that the line voltage you are connecting to is not higher
than that stated on decal or rear panel of the fixture.
This product is intended for indoor use only!
To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no flammable materials close
to the unit while operating.
The unit must be installed in a location w ith adequate ventilation, at least 50cm from adjacent surfaces. Be sure that no
ventilation slots are blocked.
Alw ays disconnect from power source before servicing or replacing lamp or fuse and be sure to replace w ith same lamp
source.
Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use its carrying handles.
Maximum ambient temperature is Ta: 40. Do not operate fixture at temperatures higher than this.
In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself. Repairs
carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance
center. Always use the same type spare parts.
Don’t connect the device to a dimmer pack.
Make sure power cord is never crimped or damaged.
Never disconnect pow er cord by pulling or tugging on the cord.
Avoid direct eye exposure to lamp. Gas discharge lamps generate UV radiation. Never operate the lamp without
appropriate protection as it could damage skin and eyes. These lamps operate at high pressures and there is always a slight
risk of tube rupture. The risk of rupture increases with age, temperature and improper handling of the lamp. These lamps
also generate UV radiation. The UV radiation that is emitted extends well below 287nm, which is considered the point at
which the UV radiation becomes imminently harmful. Exposure to this short wave UV should be limited. If aligning a
lamp, care must be taken to reduce the exposure time to the lamp. Never look directly at any lamp while it is powered on.
Read the booklet that accompanies each lamp and heed attention to the warnings concerning exposure to skin and eyes.
Use appropriate eye protection to block all UV rays. Do not use ordinary sunglasses.
There are no user serviceable parts inside the unit. Do not open the housing
or attempt any repairs yourself. In the unlikely event your unit may require
service, please contact your nearest dealer.
Caution
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance?
Page view 3
1 2 3 4 5 6 7 8 9 ... 18 19

Comments to this Manuals

No comments