Chauvet Colordash Par-Tri User Manual download pdf (Page 13)

Operation

COLORdash™ Par-Tri User Manual Rev. 03 -9-

DMX Control With ID

Addressing

In this mode, the fixtures with the same DMX starting address will respond to the DMX

controller based on the

fixture’s individual ID address setting. If the user selects ID

address “0”, all the fixtures with the same DMX address will respond in unison.

Otherwise, each fixture will follow the control for its particular ID address.

1) Repeat steps 1, 2, and 3 from DMX Control Without ID Addressing.

2) Activate ID Addressing in each fixture:

a) Go to SETTINGS.

b) Select ID ON/OFF.

c) Select ON.

Static Color

The Static Color mode allows for permanent RGB color mixing without a DMX controller.

1) Go to STATIC.

2) Select the desired color (RED, GREEN, or BLUE).

3) Select the desired color value (0~255).

4) Repeat for the other two colors.

5) Select STROBE.

6) Select the desired frequency (0~20).

Auto Programs

Auto programs allow for dynamic RGB color mixing without a DMX controller.

1) Go to AUTO.

2) Select the desired auto program (AUTO 01~10 or CUSTOM 01~10)

3) Select the speed (SP 000~255).

You cannot edit any of the auto programs (AUTO 01~10). However you can edit

custom programs CUSTOM 01~10 (see Edit Customs).

Edit Customs

This setting allows the programming of up to 30 scenes for each of the 10 customizable

programs, including colors and effects.

1) Go to EDIT.

2) Select the desired custom program (CUSTOM 01~10).

3) Select the desired scene (SCENE 01~30).

4) Select the desired color or effect (RED, GREEN, BLUE, STROBE, TIME, or FADE).

5) Select the color or effect value (000~255 for colors and timers, or 00~20 for strobe).

6) Repeat for the other colors or effects.

7) Return to the SCENE level (step “3”).

8) Repeat the settings of colors and effects for the other scenes.

Master/Slave

The Master/Slave mode allows a group of COLORdash™ Par-Tri fixtures (the slaves) to

execute simultaneously the same program, whether auto or custom, that another

COLORdash™ Par-Tri fixture (the master) is executing, and without a DMX controller.

1) Set the master unit:

a) Set the running mode to DMX as explained in “DMX Control Without ID

Addressing”

b) Select an auto program as explained in “Auto Programs”.

2) Set the slave units:

a) Go to RUN.

b) Select SLAVE.

The fixture that operates in Static mode or runs a program, whether automatic or

custom, automatically becomes the master.

• Do not connect a DMX controller to the master or slave fixtures.

• Never connect a fixture operating in Static, Auto, or Custom mode to a DMX

universe

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Comments to this Manuals

No comments

Chauvet Colordash Par-Tri User Manual Page 13

Comments to this Manuals

Related products and manuals for Floodlights Chauvet Colordash Par-Tri