Chauvet Q-Spot 200 User Manual download pdf (Page 3)

1. BEFORE YOU BEGIN

What is included

¾ 1 x Q-Spot 200™

¾ 250W MSD Lamp

¾ 5 additional metal gobos

¾ Power Cord

¾ Warranty Card

¾ User Manual

Unpacking Instructions

Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that

all parts are present, and have been received in good condition. Notify the shipper immediately and

retain packing material for inspection if any parts appear damaged from shipping or the carton itself

shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture

must be returned to the factory, it is important that the fixture be returned in the original factory box

and packing.

AC Power

To determine the power requirements for a particular fixture, see the label affixed to the back plate of

the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating is its average

current draw under normal conditions. All fixtures must be powered directly off a switched circuit and

cannot be run off a rheostat (variable resistor) or

dimmer circuit, even if the rheostat or dimmer channel

is used solely for a 0% to 100% switch. Before applying

power to a fixture, check that the source voltage

matches the fixture’s requirement. Check the fixture or

device carefully to make sure that if a voltage selection

switch exists that it is set to the correct line voltage you

will use.

Figure 1 - AC Voltage Switch

240V230V

208V

115V100V

50Hz60Hz

Warning! Verify that the voltage select switch on your unit matches the line voltage applied,

and that the frequency select switch on your unit matches the frequency of the

power in your region. Also verify that you are using the correct fuse value for your

operating voltage. All fixtures must be connected to circuits with a suitable Earth

Ground. Damage to your fixture may occur if these instructions are not followed.

POWER CABLE PIN INTERNATIONAL

BROWN Live L

BLUE Neutral N

YELLOW/GREEN Earth EG (Ground)

PERATING VOLTAGE MUST USE CORRECT FUSE

120V 6.3A

230V 3.15A

Q-Spot 200 User Manual 3 9/5/2007 2:59 PM

1 2 3 4 5 6 7 8 ... 26 27

Comments to this Manuals

No comments

Chauvet Q-Spot 200 User Manual Page 3

Comments to this Manuals

Related products and manuals for Floodlights Chauvet Q-Spot 200