Chauvet Freedom Par User Manual download pdf (Page 19)

Freedom™ series User Manual (Rev. 6) Page 19 of 28

D-Fi™ 2.4 Ghz

(DMX Mode

Auto Sync)

The Freedom™ series offers wireless control of two or more products with a single DMX

controller. To automatically set up the D-Fi™ syncing function for DMX functionality, do

the following:

For the transmitting product:

1. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.

2. Use <UP> or <DOWN> to select SYS.

3. Press <ENTER>.

4. Press <UP> or <DOWN> until S-tr appears on the display.

5. Press <ENTER>.

6. Press <UP> or <DOWN> until dtA.S appears on the display.

7. Press <ENTER>.

8. The display should show dt.AU.

For the receiving product(s):

1. Press <MODE> repeatedly until SYS, ACt, SLAv or S-1r shows on the display.

2. Use <UP> or <DOWN> to select SYS.

3. Press <ENTER>.

4. Press <UP> or <DOWN> until S-tr appears on the display.

5. Press <ENTER>.

6. Press <UP> or <DOWN> until dRA.S appears on the display.

7. Press <ENTER>.

8. The display should show dR.AU.

Once the steps above are done, press and hold <AUTO> on just the transmitter and for

approximately 30 seconds. The display and signal LED will flash to indicate sync is

activated.

You can then back out to a general menu level and configure the transmitting product to

operate it with a DMX controller.

To configure your product to work with DMX, refer to the Starting Address section of the

Operation section of this manual.

To add additional Freedom™ products, turn the synced ones off and repeat the above

steps with unsynced products. Once all products are synced, turn them all back on.

Auto scan syncing must be done within a distance of about 32 ft (10 m).

If you are experiencing antenna issues or need to improve signal quality, extend the

antenna outward away from the product and keep the line of sight between products

unobstructed.

Ensure that all linked products are configured to the same DMX personality (either

3-channel or 4-channel).

Caution: D-Fi™ operation can be interrupted or inhibited by liquid masses

between the transmitter and receiver such as water, snow, or people. For best

results, please keep the antenna clear of any liquid mass.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

Chauvet Freedom Par User Manual Page 19

Comments to this Manuals

Related products and manuals for Stroboscopes & disco lights Chauvet Freedom Par