Intimidator™ Wave IRC User Manual Rev. 1 Page 11 of 32
4. OPERATION
To access the control panel functions, use the four buttons located underneath the
display.
Button Function
<MENU>
Selects an operation mode or backs out of the current menu option
<UP>
Scrolls up the list of options or selects a higher value
<DOWN>
Scrolls down the list of options or selects a lower value
<ENTER>
Activates a menu option or a selected value
Mode Programming Levels Description
Sets DMX starting address
Run Mode
DMX
Sets DMX personality
Auto
Sets an auto program
Setup
Sets a Master mode of M-1, M-2 or M-4
Tilt Reverse
Sets reverse tilt operation
Tilt Angle
Sets tilt angle range
Display
Sets display blackout
Screen Reverse
Sets screen orientation
Resets all motor defaults
Resets to factory defaults
System Info
Displays software version
Displays current operating mode
Displays current DMX address
(DMX)
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you
choose a starting address that is too high, you could
restrict the access to some of the product’s channels.
The Intimidator™ Wave IRC uses up to 34 DMX channels in its 34-channel
which defines the highest configurable address to 479.
If unfamiliar with DMX, download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MENU>
2. Use <UP> or <DOWN> to select the Address.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to enter your starting address.
5. Press <ENTER>.
Comments to this Manuals