Chauvet LED Pinspot 360 User Manual download pdf (Page 6)

LED Pinspot 360 User Manual 6 Rev. 2

3. SETUP

AC Power

This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage

to which you are connecting it is within the range of accepted voltages.

Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat

(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0

to 100% switch.

To determine the power requirements for a particular fixture, see the label affixed to the back plate of

the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its

average current draw under normal conditions.

Always connect the fixture to a circuit with a suitable electrical ground.

Lens Replacement

This fixture comes with an optional lens that modifies the beam angle. Please see the instructions

below for instructions on replacing the lens.

1. Remove the retainer ring.

2. Remove the lens (the lens will fall out without the retainer ring installed).

3. Insert the new lens. Use caution, as it may fall out until the retainer ring is installed in step #4!

4. If installing a color gel, place this between the retainer ring and the lens.

5. Install the retainer ring.

6. Assure that the installation is tight.

If the lens is not installed properly, it may fall out. This may be a safety hazard if installed overhead.

Lens

Retainer Ring

Color Gel

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Chauvet LED Pinspot 360 User Manual Page 6