LED Pinspot 360 User Manual 9 Rev. 2
4. OPERATING INSTRUCTIONS
Configuring the Starting Address
Each fixture requires a starting address from 1~512. A fixture requiring one or more channels for control begins
to read the data on the channel indicated by the starting address. For example, a fixture that uses seven DMX
channels and is addressed to start on DMX channel 100, will read data from channels: 100, 101, 102, 103, 104,
105 and 106. Choose the starting addresses for each fixture so that the channels used do not overlap. In
addition, you should note the starting address selected for future reference. The LED Pinspot 360 uses five
DMX channels. If you are unfamiliar with DMX, download the DMX Primer from www.chauvetlighting.com.
DMX Operation
This is the operating mode which will allow for control with an external DMX controller. You must set the starting
address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX
Primer” section in the “Appendix” of this manual.
1. Set DIP switch [10] to the “ON” position.
2. Use DIP switches 1~9 to set the DMX starting address.
Master/Slave
This is the operating mode which will allow 1 fixture to act as the “master” and control all of the other “slave”
fixtures. You must set both the master and the slave(s) fixtures to the correct mode for this operation.
Master Setting: Set the DIP switches for this fixture by using the below Standalone settings. This
automatically sets the fixture to Master.
Slave Setting: Set the DIP switch [10] to the ON position.
It is not necessary to set the master fixture as the first fixture in the daisy chain. It may be any
fixture in the daisy chain. For example: fixture 2, 5, 10 or 12, etc.
Only 1 fixture may be set to master.
Do not connect a DMX controller to the daisy chain for this operating mode.
Standalone Operation
Automatic
This product has preprogrammed auto programs. These are accessed via the DIP switches, and the
movement range of the pan may be selected by choosing the appropriate DIP switches. Please see the
chart below for further explanation.
Auto with movement range of 90°
Auto with movement range of 180°
Auto with movement range of 270°
Auto with movement range of 360°
Auto with movement range of 540°
Sound-Active
The preprogrammed sound triggered programs are accessed via DIP switches, and the movement range
of the pan may be selected by choosing the appropriate DIP switches. The sound sensitivity may be
adjusted using the audio adjustment knob. Please see the chart below for further explanation.
Sound with movement range of 90°
Sound with movement range of 180°
Sound with movement range of 270°
Sound with movement range of 360°
Sound with movement range of 540°
(28 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals