Chauvet Freedom Par User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 21
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
Freedom™ Par Quad-4 User Manual Rev. 1 Page 13 of 21
D-Fi™ 2.4 GHz
(DMX Mode
Auto Sync)
The Freedom™ Par Quad-4 offers wireless control of 2 or more products with a single DMX controller. To
automatically set up D-Fi2.4 GHz syncing for DMX, do the following:
For the receiving product(s):
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until drAS appears on the display.
4. Press <ENTER>.
5. The display should show drAU.
For the transmitting product:
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until dtAS appears on the display.
4. Press <ENTER>.
5. The display should show dtAU.
Receiving units must be set up before the transmitting unit. Once the steps above are done, press and
hold <AUTO>
on just the transmitter for approximately 30 seconds. The display and signal LED will flash
to indicate sync is activated.
You can then back out to a general menu level and configure the transmitting product to operate it with a
DMX controller.
To configure your product to work with DMX, refer to the Starting Address section.
To add additional Freedom™ products, turn the synced ones off and repeat the above steps
with unsynced products. Once all products are synced, turn them all back on.
Auto scan syncing must be done within a distance of about 32 ft (10 m).
Manual syncing is recommended for best results when adding products after initial system
setup.
If you are experiencing issues or need to improve signal
quality, keep the line of sight
between products unobstructed.
Ensure that all linked products are configured to the same DMX personality.
Caution: D-Fi™ 2.4 GHz operation can be interrupted or inhibited by liquid masses between the
transmitter and receiver such as water, snow, or people. For best results, keep the line of sight
clear of any liquid mass.
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments