Chauvet SPOT LED 450 User Manual download pdf (Page 18)

Page 18 of 21 Intimidator™ Spot LED 450 User Manual Rev. 2

Changing

Gobos

To change the gobos in the Intimidator™ Spot LED 450,

you do not need to remove

the gobo wheel. Simply:

1. Turn off and disconnect fixture from power outlet.

2. Place the product on a flat, level surface with the top facing up.

3. Access the gobo plate by removing the cover on the moving head. By hand, gently

pry up the right side, and then push right with the indented handles.

NOTE: If you expose the driver board, you are on the wrong side of the head.

Replace the cover immediately and remove the cover on the opposite side of the

moving head.

4. Rotate the gobo wheel until the gobo that needs replacing is accessible.

5. Separate the gobo holder assembly away from the gobo wheel by pushing it

forward and up. Be careful not to push the gobo out of the gobo plate.

6. Extract the gobo holder by pulling it outward (straight up).

7. On a flat surface, remove the expansion ring that holds the gobo in place and

remove the gobo from the gobo plate.

8. Insert a new gobo and hold it in place with the expansion ring.

9. To re-insert the new gobo, slide the tip of the gobo holder under the pressure plate

near the center of the gobo wheel.

10. Push the gobo holder assembly inwards. DO NOT force the gobo holder into the

gobo wheel slot. Slightly move the holder from side-to-side if needed to get it to seat

properly. If correctly installed, the bottom of the holder will be flush with the gobo

wheel.

11. Push cover back into position.

Expansion Ring

Gobo

Gobo Holder

Gobo Wheel Detail Views

Gobo Replacement Diagram

Gobo Holder Removal

Easy-access

Panel

1 2 ... 13 14 15 16 17 18 19 20 21

No comments

Chauvet SPOT LED 450 User Manual Page 18