Setup
-6- Q-Wash™ 436Z-LED User Manual Rev. 2
3. Setup
Each Q-Wash™ 436Z-LED has an auto-ranging power supply that works with an input
voltage range of 100~240 VAC, 50/6
0 Hz. To determine the power requirements for
each Q-Wash™ 436Z-LED
, refer to the label affixed to the product. You can also refer to
the Technical Specifications chart in this manual.
The listed current rating in
dicates the maximum current draw during normal operation.
For more information, you may download Sizing Circuit Breakers from the Chauvet
website: www.chauvetpro.com.
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0% to 100% switch.
The Q-Wash™ 436Z-LED comes with a power input cord terminated with a Neutrik®
powerCON® A connector on one end and an Edison plug on the other end (U.S.
market). If the power input cord that came with your product has no plug, or if you
to change the Edison plug, use the table below to wire the new plug.
Connection Wire (US) Wire (Europe) Screw Color
Make sure to disconnect the product’s power cord before replacing a blown fuse.
Always replace the blown fuse with another of the same type and rating.
1. Disconnect the product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with another fuse of the same type and rating
(6.3 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Comments to this Manuals