Page 14 of 18 Intimidator™ Barrel LED 300 User Manual (Rev. 5)
(Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode
controller. Products in standalone mode could interfere with the controller.
Sound Active
Mode
To enable the Sound Active mode, do the following:
1. Press <MODE/ESC> repeatedly until one of the following shows on the display:
NASl, NAFA, NStS, or SLAv.
2. Press <UP> or <DOWN> to select NStS.
3. Press <ENTER>.
4. Turn the music on and adjust the microphone sensitivity knob until the product
starts responding to the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
To enable the Automatic Mode:
1. Press <MODE/ESC> repeatedly until one of the following shows on the display:
NASl, NAFA, NStS, or SLAv.
2. Press <UP> or <DOWN> to select NASl (for a slow light show) or NAFA (for a fast
light show).
3. Press
.
Operation
To select whether you want the Intimidator™ Barrel LED 300 to operate with normal
panning or inverted panning, do the following:
1. Press <MODE/ESC> repeatedly until PAn shows on the display.
2. Press <UP> or <DOWN> to select normal pan operation (PAn) or inverse pan
operation (r PAn).
You are able to flip the LED display for easy readability in any mounting situation. To
select your display angle:
1. Press <MODE/ESC> repeatedly until diS shows on the display.
2. Press <UP> or <DOWN> to select normal display mode (diS) or inverse display
mode (r diS).
Reset Software
To reset the software on the Intimidator™ Barrel LED 300:
1. Press <MODE/ESC> repeatedly until rESt shows on the display.
2. Press <ENTER>.
The product will reset all settings in the software to the default
factory settings.
Replacement
The Intimidator™ Barrel LED 300 has replaceable gobos:
1. Turn off and disconnect product from power.
2. Open the head cover by loosening the 10 fastening screws at the sides of the top
cover.
3. Remove the 4 screws on the cover plate underneath the display to access the gobo
wheel.
4.
Separate the gobo plate away from the gobo wheel by pushing it toward the front of
the mirror. Be careful not to push the gobo out of the gobo plate.
5. Then extract the gobo plate by pulling it outward.
6. On a flat surface, remove the expansion ring that holds the gobo in place and
remove the gobo from the gobo plate.
7. Insert a new gobo and hold it in place with the expansion ring.
8. Slide the tip of the gobo plate under the pressure plate near the center of the gobo
wheel.
9. Push the gobo plate inwards. DO NOT force the gobo plate into the gobo wheel
slot. If correctly installed, the gobo plate should accommodate itself in the gobo
wheel slot.
10. Replace cover.
(27 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals