Chauvet INTIMIDATOR 200 User Manual download pdf (Page 7)

Intimidator™ Barrel LED 300 User Manual (Rev. 5) Page 7 of 18

3. SETUP

AC Power

The Intimidator™ Barrel LED 300

has a dual voltage power supply and it can work with

an input voltage of either 120 V, 60 Hz or 230 V, 50 Hz, depending on the position of the

voltage selection switch.

To determine the product’s power requirements (circuit breaker, power outlet, and

wiring), use the current value listed on the label affixed to the product’s back panel, or

refer to the product’s specifications chart. The listed current rating indicates the

product’s average current draw under normal conditions.

Always connect the product to a protected circuit

(circuit breaker or fuse). Make

sure the product has

an appropriate electrical ground to avoid the risk of

electrocution or fire.

Never connect the product to

a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse

Replacement

Follow the instructions below to change the fuse, if necessary.

Disconnect the product from the power outlet before replacing the fuse.

1. Disconnect this product from the power outlet.

Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.

3. Remove the blown fuse and replace with a good fuse of the same type and rating.

4. Screw the fuse holder cap back in place and reconnect power

The product does not ship with a spare fuse; however, the safety cap has room

for a spare.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

No comments

Chauvet INTIMIDATOR 200 User Manual Page 7